I am running v 1.0.3 of the ESTK. When I run a bridge script from a context menu in Bridge, with a debugger break
$.level=1;
debugger;
The script breaks, and the ESTK is okay for about 3 seconds and then it goes white and crashes.
Has anyone else encountered this behavior?
Windows XP, CS2
ESTK crashing when debugging under Bridge
ESTK crashing when debugging under Bridge
Further to this problem, here is a sample script that creates a menu item in the context thumbnail menu in Bridge if you save this script as a jsx file and place it in your StartUpScripts folder.
When this script runs, the debugger halts at the debugger statement, the line is highlighted in yellow and the cursor is frozen at the start of the line (it does not blink). About 3 seconds later the ESTK crashes.
Could someone else please try this on their computer to see if you can duplicate this behavior. Any suggestions would be most appreciated.
Thanks.
Here is the script:
#target bridge
$.level = 0;
if ( BridgeTalk.appName == "bridge" ) { // only load into bridge
// create menu
var cmdMenuShell = new MenuElement('command', 'Menu shell ...', 'before Thumbnail/Cut-');
// execute menu
cmdMenuShell.onSelect = function() {
$.level=1; debugger;
alert("Hello Menu shell");
}
}
When this script runs, the debugger halts at the debugger statement, the line is highlighted in yellow and the cursor is frozen at the start of the line (it does not blink). About 3 seconds later the ESTK crashes.
Could someone else please try this on their computer to see if you can duplicate this behavior. Any suggestions would be most appreciated.
Thanks.
Here is the script:
#target bridge
$.level = 0;
if ( BridgeTalk.appName == "bridge" ) { // only load into bridge
// create menu
var cmdMenuShell = new MenuElement('command', 'Menu shell ...', 'before Thumbnail/Cut-');
// execute menu
cmdMenuShell.onSelect = function() {
$.level=1; debugger;
alert("Hello Menu shell");
}
}
ESTK crashing when debugging under Bridge
I haven't done any Bridge scripting so I can't help you with this other than to say that when I followed your instructions with ESKT open it crashed even faster than you described. I didn't even get the 3 sec highlight.
But if I run it with ESTK closed, the ESTK opens and the script works like I think it would. I get an alert in Bridge.
CS2, ESTK 1.0.3, WinXP
Hope that helps,
Mike
But if I run it with ESTK closed, the ESTK opens and the script works like I think it would. I get an alert in Bridge.
CS2, ESTK 1.0.3, WinXP
Hope that helps,
Mike
ESTK crashing when debugging under Bridge
Thanks Mike
It is good to know it is not just me...
It is good to know it is not just me...